Table of Contents
Advertisement
6.
Charging and Installing the Battery
In this procedure you will charge and then install and secure the battery.
1. Charge the battery, using the included battery charger, until it is fully
charged as indicated by the LED on the charger. Charging usually requires
8 continuous hours but may vary depending on your configuration.
NOTE: Some international models may not include a battery or battery charger.
2. Open the bottom back zipper on the portable case, and install the battery
in the battery well. While holding the tie-down straps out of the way,
make sure the power cable is fitted snugly into the slot in the well so that
the battery does not rest on it (see the illustration Installing the Battery).
Installing the Battery
3. Pull the two battery tie-down straps over the top of the battery and
connect both ends of each strap over the top, making sure that the
straps are pulled tight around the battery and that the battery is
seated securely in the battery well.
4. Zip up the back opening.
NOTE: Do NOT connect the power cable to the battery at this time. You should
wait until just before fishing to connect the power cable to the battery.
Tying Down the Battery
9
Advertisement
Table of Contents
