Table of Contents
Advertisement
NTC-6200-01, NTC-6200-02, NTC-6200-11 and NTC-6200-12
NTC-6200-03 and NTC-6200-13
Failover power support (NTC-6200-01 and NTC-6200-11 only)
The NTC-6200-01 and NTC-6200-11 routers include support for connection of two power sources at the same time. When a PoE
Ethernet cable is connected and DC power is also supplied to the DC input jack of the router, the router will source power
exclusively from the PoE source. In the event that power from the PoE cable is lost, the router will automatically switch to source
power from the DC input jack, without affecting the router's operation. When PoE power is restored, the router automatically
switches back to receive power from the PoE input source.
Viewing power source information
You can view the current power input mode in the Advanced status section of the device's web user interface. This is useful for
remotely monitoring the device. You can also use the Software Development Kit to access this information for advanced purposes
(e.g. configuring SMS alerts to inform you of the power status of the router).
www.netcommwireless.com
Figure 12 – Locking Six-way Power Terminal Block
Figure 13 – Terminal block connector
TERMINAL
+
Positive wire for power.
-
Ground wire.
i
Dedicated terminal for ignition detection.
Three terminals used for input/output detection (refer to the
I/O
configuration
section for more information).
Table 9 - Locking power block pin outs
Figure 14 – Locking Two-way Power Terminal Block
PIN
SIGNAL
+
V+
-
V-
Table 10 - Locking power block pin outs
DESCRIPTION
IO
DESCRIPTION
Voltage +
Ground
NetComm Wireless 3G M2M Router / Plus
17
Advertisement
Table of Contents
