SHERCO 2013 SE 250i-R Shop Manual page 29

Reassembling the ignition case:
•
Apply grease to the caged needle
bearing and reinstall it.
•
Reinstall the two starter shafts and their
gears.
•
Visually inspect the oil seal on the oil
centrifuge.
•
Use special tool number 1818 to install
the oil centrifuge.
Tighten the oil centrifuge fixing screw to the
appropriate torque.
This screw thread is reversed, it is a LH
thread.
•
Screw and tighten the centrifuge.
Torque the centrifuge fixing screw to: 8 Nm.
•
Inspect the
necessary.
•
Install the rotor (turn the rotor counter
clockwise to help facilitate the installation of the
lighting rotor).
•
Apply proper tightening torque to the nut
on the rotor with strong threadlocker.
•
Install the conical washer.
•
Using special tool number 1815 to hold
the rotor tighten the fixing nut.
Torque the fixing clutch nut to 80 Nm with
medium threadlocker.
•
Install the remaining shafts and gears.
•
Install the two case locating pins.
•
Install a new gasket.
•
Install the ignition crankcase cover and
tighten the 10 screws.
Torque the ignition crankcase cover screws
to: 10 Nm.
rotor key, change if
28/54