Removing the clutch hub and the clutch basket:
•
Drain the engine oil and the engine
coolant.
•
Remove
the
disassembling the right side paragraph)
•
Remove the clutch. (see clutch removal
paragraph)
•
Remove the clutch release bearing
assembly.
•
Retain the clutch hub using tool 1814.
•
Loosen the clutch hub nut.
Attention, make sure the special timing
tool number 1819 is not installed, if it is, severe
damage could occur to the crankshaft and
crankcase.
•
Remove the hub and the nut.
•
Inspect the needle bearings and replace
if necessary.
•
Visually inspect the hub and the housing.
Reassembling the clutch hub components:
•
Install the thrust washer.
•
Install the needle bearings.
•
Install the clutch housing.
•
Install the spacer washer.
•
Install the clutch hub.
•
Apply engine oil to the shaft threads and
the fixing nut.
•
Install the conical washer.
•
Install the fixing nut.
Torque the fixing nut to:
80Nm.
•
Check for free rotation of the clutch hub.
•
Reinstall the clutch release bearing
assembly, the clutch and the clutch housing in
the reverse order of their removal.
clutch
housing.
(see
25/54