SHERCO 2013 SE 250i-R Shop Manual page 28

•
Remove the flywheel using special tool
number R462.
•
Remove the two starter shafts along with
the starter gears.
•
Remove the oil centrifuge (anti blowby)
Attention the threads this screw are LH,
do not turn the wrong direction.
• Remove the freewheel. (see photo)
Inspect the freewheel and the needle bearings:
• Visually inspect the caged needle bearings.
• Replace if necessary.
• Inspect the condition of the freewheel.
• Replace if necessary.
• Finally check the rollers on the freewheel.
• Replace if necessary.
If the freewheel must be replaced then
the rest of the gears must be replaced and vice
versa.
27/54