•
Install the wrist pin into the piston and
connecting rod using the tool and lightly tapping
with a hammer.
•
Install the opposite circlip, using the
special tool.
•
Install the cylinder over the piston using
an appropriate ring compressor.
•
Install the two cylinder head locating pins
[A].
•
Install the head gasket [B].
•
Install the cylinder head.
•
Install the head bolts noting the different
lengths; tighten them using two passes in the
order shown in the photo.
•
Install and tighten the two M6 nuts.
Cylinder head torque:
st
Studs
1
pass: 30 Nm
nd
2
pass: 50 Nm
Nuts M6: 10 Nm
The two internal bolts are of different
length and are equipped with washers.
A
2
3
4
1
18/54
B