Wall Mount; Countertop Mount - Datalogic Magellan 3200VSi Product Reference Manual

Getting Started
Figure 4. Using the Risers

Wall Mount

Attach the L-Bracket to the wall, securing it in the desired position with two screws through the
two holes in the back face of the L-Bracket as shown in
Head (8.2mm or 5/16" maximum head diameter) #8 screw with a thread profile that suits the
mounting surface material in the wall.

Countertop Mount

If using the L-Bracket alone for countertop installation, secure the bracket in place using two
screws through the bottom face of the bracket (see
the countertop by attaching two screws through its screw holes. Recommendation: Use two Pan
Head (8.2mm or 5/16" maximum head diameter) #8 screw with a thread profile that suits the
mounting surface material in the countertop.
Risers may be stacked as shown in
scanner by 1.5" (38.1mm). Riser pieces readily snap together or apart and allow for adjustable
tilt of the scanner/L-Bracket of up to 20 degrees in 5° increments.
of a tilted scanner.
6
a
One Riser
Do not use a countersink type of screw head. Damage will occur from
use of a countersunk screw head in the plastic screw bosses
CAUTION
b
Two Risers stacked. Scanner and
L-Bracket have been tilted on the
top Riser.
Figure 3
). If risers are used, secure a riser to
Figure 3
b. Each riser increments the height of the mounted
Figure 4
. Recommendation: Use two Pan
b provides an example
Figure 4
Magellan TM 3200VSi