Network Menu (Setup) - Merging Horus User Manual

Backlight:
Cooling Mode:

Network Menu (Setup)

Device Name:
IP Settings:
Address:
Netmask:
Apply & Reboot:
Dim active will darken the Horus display luminosity. When active this saves
some power and hence some internally generated heat.
Settings for either Low, Mid or High Cooling. This affects fan speed with
reference to the temperature measured internally. While there is no universal
preferred setting, we recommend that unless noise levels are a concern, you
leave the setting on Mid or High for coolest operation and best protective
results.
- Low: Fan starts above 45°C
- Mid: Fan starts above 35°C
- High: Fan always on at lowest speed (less noise), speed starts rising above
25 °C
Name of the Horus unit. This name will be broadcast across the network and
will be seen in applications such as the MT Discovery tool. The Horus unit
name can be changed from the Web control access Network page (see section
below for all details)
Manual: Type IP address using box selection and the - or + buttons
Auto: The IP address will be automatically attributed using ZeroConf/Auto-IP
mechanism (address range 169.254.xx.xx if no DHCP server is present)
Set the IP Address for the Horus unit by using box selection and the - or +
buttons (Available only with IP Settings = Manual)
Set the Subnet Mask for the Horus unit by using box selection and the < or >
buttons (Available only with IP Settings = Manual)
Once changes have been made to this section, you must press this button to
save the settings and power cycle the Horus unit
www.merging.com/horus
Horus User Manual
Page 52