Merging Horus User Manual page 67

Note: If you wish to cancel the Horus Maintenance mode you can do so from the Web access
page or by pressing the small physical power button, this will reboot the Horus in normal mode.
You can also press the small triangle button in order to reboot the Horus. Be aware that the
small triangle button is only active for reboot when in Maintenance mode.
Warning: We do not recommend that you refresh the browser page or restart the Horus while a
firmware update is in progress and we recommend only gigabit Ethernet port or switch
connection. Refer to the Merging RAVENNA Network Guide for example
http://www.merging.com/products/horus/downloads
6) Open the MTDiscovery tool, you should see a device called "Horus in Maintenance Mode",
double-click on it.
MT Discovery is installed with Pyramix v8/v9. But for Horus standalone users it can also be
downloaded from
http://www.merging.com/products/horus/downloadshttp://www.merging.com/horus/download
Note: If you do not see the Horus Maintenance Mode entry, reboot Horus in Maintenance mode and verify
your Horus Ethernet Connection to the MassCore Gb Ethernet Card.
If you still do not see the Horus maintenance mode under MT Discovery. Open your Windows Device
Manager and look in the Network Adapter section. Disable and re-enable the Merging Technologies PCIe
Ethernet controller.
Warning: Horus Maintenance mode uses Auto IP config. Therefore en sure that you the PC is configured
to obtain an IP address automatically when performing a firmware update.
www.merging.com/horus
Horus User Manual
Page 67