Table of Contents
Advertisement
Horus User Manual
Installing the Merging PCIe Ethernet Controller Card
NET-MSC-GBEX1
Detailed steps on how to install the NET-MSC-GBEX1 PCIe card in your PC.
1. Power down your PC and switch it off at the wall. Remove the screws holding the top or side of the
case on and carefully slide off the panel.
2. Wearing an anti-static wristband is desirable whenever working with sensitive electrical equipment.
Keeping one hand on a metal part of the case will have the same effect, though you may need both
hands when installing certain items of hardware.
3. Locate an empty PCIe slot and remove the metal backing plate by removing the screw holding it in
place and carefully sliding it up and out. In some cases, there are no backing plates and you will need
to remove a length of metal instead. Do this using a flat-blade screwdriver and/or pliers, taking care to
avoid any sharp edges left behind.
4. Next, remove the NET-MSC-GBEX1 card from its envelope bag and line it up with the vacant PCIe
slot as shown below.
www.merging.com/horus
Page 31
Advertisement
Table of Contents
