Merging Horus User Manual page 74

Cannot access Horus remotely in Maintenance mode for Firmware update
Procedure:
1. First launch MTDiscovery and open the Horus Maintenance Mode entry
2. If such entry does not show up, reboot your system and retry
3. If it still does not work, make sure that your Network card is set to Automatic IP addressing (see
page 58 above)
4. If case none of the above works, make sure that the Horus if well connected to your system via
Ethernet. It is mandatory that the Ethernet port or Switch is a Gigabit one.
5. Make sure that the Ethernet cable is Cat 5E or 6
6. On the Horus Maintenance TFT screen take note of the written IP Address
7. Type this address in your Chrome browser followed by :8080
Example: 169.254.182.31:8080
You should now have access to the Horus remote Maintenance page and be able to update
your Horus firmware.
www.merging.com/horus
Horus User Manual
Page 74