Info (Setup) - Merging Horus User Manual

Info (Setup):

In this sub menu you will find details about the Horus internals; current consumption, voltage,
temperature, fan speed, serial number and the firmware version currently installed.
Note:
Horus has no DHCP-server capability neither does the Merging PCIe Ethernet
Controller Card NET-MSC-GBEX1.
By default the Horus IP setting is set to "Auto" configuration mode which gives
an address in the range 169.254.xxx.xxx if no DHCP server is present on the
network. Users are free to put a DHCP server in their RAVENNA network with
a customized address range and the Horus would get an IP address from this
server. Note that our recommended Dell PowerConnect 2816 RAVENNA
switch is configured with DHCP disabled.
Merging recommend the Horus to be configured in "Auto" mode and the
Merging PCIe Ethernet Controller Card NET-MSC-GBEX1 to also be
configured with "Internet Protocol Version 4" with "Obtain an IP automatically".
You must be aware that when the Horus is started in Maintenance mode the IP
configuration is exclusively done using "Auto" IP settings mode.
www.merging.com/horus
Horus User Manual
Page 53