Operating Instructions - Worx WXI 60 Safety And Operating Manual

A
B
10
Lithium-ion
cordless drill/driver

OPERATiNG iNSTRUcTiONS

Note: Before using the tool, read the instruction
book carefully.
INteNDeD USe
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and
plastic.
C1
BefoRe PUttING INto oPeRAtIoN
A) cHARGING tHe BAtteRy
The battery charger supplied is matched to the Li-Ion
battery installed in the machine. Do not use another
battery charger.
The Li-Ion battery is protected against deep
discharging. When the battery is empty, the machine is
switched off by means of a protective circuit: The tool
holder no longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
When the battery pack is charged for the first time and
C2
after prolonged storage, the battery pack will accept a
100% charge after several charge and discharge cycles.
B) to ReMove oR INStAll BAtteRy PAck
(See fig. A)
Depress the battery pack release button to release
and slide the battery pack out from your tool. After
recharge, slide it back into your tool. A simple push
and slight pressure will be sufficient.
oPeRAtIoN
1. oN / off SWItcH (See fig. B)
Depress the On/Off switch to start and release it to
D
stop your drill. The on/off switch is fitted with a brake
function which stops your chuck immediately when
you quickly release the switch.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger
depression.
WARNING: Do not operate for long periods
at low speed because excess heat will be
produced internally.
2. SWItcH lock
The switch trigger can be locked in the OFF position.
E
This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger,
F
G
H
WX160 WX163