Assembly And Operation; Operating Instructions - Worx WX152 Original Instructions Manual

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in
wood, metal and plastic.

ASSEMBLY AND OPERATION

Action
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger
switch and disconnect tool from power
source when changing accessories. Always
ensure the bit is secure before starting the tool.
Damage to the Chuck or a loose bit may cause
possible personal injury.
--Removing the bits
--Inserting the bits
OPERATION
Forward/reverse rotation
control
WARNING: Never
change the direction
of rotation when the
chuck is rotating, wait
until it has stopped!
Lithium-Ion Cordless Drill/Driver
TWO-SPEED GEAR
CONTROL
TORQUE ADJUSTMENT
DRILLING,SCREWDRIVING,
HAMMER DRILLING
Operating the on/off switch
periods at low speed
Figure
because excess heat will
be produced internally.
LED Light Indicator
See Fig. A1
Before operation, the LED light will be
activated when the On/Off switch is slightly
depressed, and will automatically turn off 20
seconds after the On/Off switch is released.
See Fig. A2
The tool and battery are equipped with a
protection system. When the LED Light is
quickly flashing 3 seconds and turn off, the
See Fig. A3
system will automatically cut off power to
the tool to extend battery life. The tool will
automatically stop during operation if the tool
and/or battery are placed under one of the
following conditions:
• Overloaded: The tool is operated in a
manner that causes it to draw an abnormally
high current. In this situation, release the
Trigger Switch on the tool and stop the
application that caused the tool to become
overloaded. Then pull the Trigger Switch again
to restart.
• Overheated: Under the condition above, if
See Fig. B2
the tool does not start, the Tool and Battery are
See Fig. B1
overheated. In this situation, let the Tool and
Battery cool before pulling the Trigger Switch
again.
• Low battery voltage: The remaining
Battery capacity is too low and the tool will not
operate. In this situation, remove and recharge
the Battery.
See Fig. C1,
C2, C3
Forward/Reverse Rotation Control is on
right/left position.
WARNING: Do not
operate for long
WARNING: To turn on the light, press
the On/Off switch and make sure the
See Fig. D
See Fig. E
See Fig. F
11
EN