Intended Use; To Remove Or Install Battery Pack; Switch Lock; Operating Instructions - Worx WX125 Safety And Operating Manual

Lithium-ion cordless drill/driver
Hide thumbs Also See for WX125:
Table of Contents

Advertisement

8
A
B
Lithium-Ion
cordless drill/driver

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction
book carefully.

INTENDED USE

The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched
off by means of a protective circuit: The tool holder no
longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
When the battery pack is charged for the first time and
after prolonged storage, the battery pack will accept a
100% charge after several charge and discharge cycles.
B) TO REMOVE OR INSTALL BATTERY PACK
(See Fig.A)
Depress the battery pack release button to release and
slide the battery pack out from your tool. After recharge,
slide it back into your tool. A simple push and slight
pressure will be sufficient.
OPERATION
1. ON / OFF SWITCH (See Fig.B)
Depress the On/Off switch to start and release it to stop
your drill. The on/off switch is fitted with a brake function
which stops your chuck immediately when you quickly
release the switch.
C
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger
depression.
WARNING: Do not operate for long periods
at low speed because excess heat will be
produced internally.

2. SWITCH LOCK

The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental starting
when not in use. To lock the switch trigger, place the
rotation control in the center position.
D
WX125 WX125.1
WX1 25.4
F

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wx125.1Wx125.4

Table of Contents