Assembly And Operation; Operating Instructions - Worx WX178L Operating Instructions Manual

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.

ASSEMBLY AND OPERATION

BEFORE OPERATION
Removing the Battery Pack
Charging the Battery Pack
Installing the Battery Pack
ASSEMBLY
Bit Lock Adjustment
TM
WARNING: Always ensure the bit is secure before starting the tool.
Damage to the Chuck or a loose bit may cause possible personal injury.
NOTE: When the chuck jaws become fully opened or closed, the clutch will
activate, making a clicking sound. This sound is normal.
If the Bit Lock Switch (10) does not operate, confirm the battery is charged and
TM
depress the trigger briefly.
Keep drill tilted upward when adjusting the chuck to prevent bit from falling out.
--Inserting the Bits
--Removing the Bits
OPERATION
Forward/Reverse Rotation Switch
WARNING: Never change the direction of rotation when the Chuck is
rotating. Wait until it has stopped!
Function Mode Selection
Press the function button to select operation mode. The button will illuminate
in blue for a few seconds. Depress the Variable Speed Switch (9) slightly to
illuminate the function button again .
Drive Mode with Safe Drive
• When driving a screw, the tool automatically stops as the screw head becomes
flush with surface of workpiece. If a deeper screw is desired, continue to depress
the Variable Speed Switch (9). The tool will make slow rotations to drive the screw
deeper.
• Once the desired depth is reached, release the Variable Speed Switch (9).
NOTE: If the tool stops sooner than desired, release the Variable Speed Switch (9)
and press it again to reset the tool.
Drill Mode
Drill / Driver
ACTION FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
11
See Fig. B1
See Fig. B2
See Fig. C1,
C2, C3
See Fig. D
See Fig. E
EN