Problem Solution - Worx WXI 60 Safety And Operating Manual

applying only enough pressure to keep
the bit cutting. Do not force or apply side
pressure to elongate a hole.
tungsten carbide drill bits should
always be used for concrete and
masonry. When drilling in metal, only
use HSS drill bits in good condition.
Always use a magnetic bit holder (not
included) when using short screwdriver
bits. When screw-driving, apply a small
quantity of liquid soap or similar to the
screw threads to ease insertion.
11. DISPoSAl of AN eXHAUSteD
BAtteRy PAck
To preserve natural resources, please
recycle or dispose of the battery
pack properly. This battery pack
contains Lithium batteries. Consult your local
waste authority for information regarding
available recycling and/or disposal options.
Discharge your battery pack by operating
your drill, then remove the battery pack
from the drill housing and cover the battery
pack connections with heavy-duty adhesive
tape to prevent short circuit and energy
discharge. Do not attempt to open or remove
any of the components.
12. oveRloAD PRotectIoN
When overloaded, the motor comes to
a stop. Relieve the load on the machine
immediately and allow cooling for approx. 30
seconds at the highest no-load speed.
13. teMPeRAtURe DePeNDeNt
oveRloAD PRotectIoN
When using as intended for the power tool
cannot be subject to overload. When the
load is too high or the allowable battery
temperature of 75°C is exceeded, the
electronic control switches off the power
tool until the temperature is in the optimum
temperature range again.
14. PRotectIoN AGAINSt DeeP
DIScHARGING
The Li-Ion battery is protected against deep
discharging by the "Discharging Protection
System". When the battery is empty, the
Lithium-ion
cordless drill/driver
machine is switched off by means of a
protective circuit: The inserted tool no longer
rotates.

PROBLEM SOLUTiON

1. WHy DoeS tHe DRIll Not tURN oN
WHeN yoU PReSS tHe SWItcH?
The forward/reverse rotation control, which
is on top of the trigger, is positioned in the
lock function. Unlock the forward/reverse
rotation control by putting it into the required
rotation position. Push the trigger and the
drill will start to rotate.
2. tHe DRIll StoPS BefoRe tHe
ScReW IS coMPletely tIGHteNeD.
WHy?
Verify the torque position of the torque
adjusting ring, you can find the torque-
adjusting ring between the chuck and the
drill body. Position 1 is the lowest torque
(screw driving force) and position 23 is the
highest torque (screw driving force). Position
24 is for drill operation. Regulate the torque
adjusting ring to a higher position to reach
the best result.
3. ReASoNS foR DIffeReNt BAtteRy
PAck WoRkING tIMeS
Charging time problems, as above, and
having not used a battery pack for a
prolonged time will reduce the battery pack
working time. This can be corrected after
several charge and discharge operations by
charging & working with your drill. Heavy
working conditions such as large screws
into hard wood will use up the battery
pack energy faster than lighter working
conditions. Do not re-charge your battery
pack below 0 C and above 45
o
affect performance.
WX160 WX163
13
C as this will
o