Table of Contents
Advertisement
The miter gauge can be adjusted so it is perpendicular to
the blade and so it is snug in the T-slot.
90° Square .......................................................1
45° Square .......................................................1
Hex Wrench 2.5mm .............................................1
Hex Wrench 2mm ...............................................1
Hex Wrench 3mm ...............................................1
DISCONNECT THE SAW FROM POWER!
Slide the miter gauge into the T-slot on the table.
Loosen the miter gauge lock knob, pull out the
positive stop knob, then pivot the miter gauge body
to 90° so the stop knob springs into position.
Place the 90° square evenly against the face of the
miter gauge and the blade, as shown in
— If the square touches the miter body and the body
of the blade (not the teeth) evenly at the same
time, then it is square to the blade and the 90°
stop is set correctly. No further adjustments are
necessary.
— If the square does not touch the miter body and
blade body evenly at the same time, then proceed
to
.
Loosen the button head cap screws on the positive
stop knob block (see
body until it is flush with the square, then tighten the
screws.
Loosen the screw on the front of the miter bar, adjust
the pointer to 0°, then tighten the screw.
The miter bar can be adjusted so it fits more tightly in
the miter slot.
To adjust the miter bar tightness, loosen the cap screw
on each guide block (see
screws as needed, then tighten the cap screw.
.
), adjust the miter
), adjust the set
-72-
Checking 90° stop on miter
gauge.
Positive
Stop Knob
Button Head
Cap Screws
Screws for adjusting miter
gauge body.
Set Screws
Cap Screws
Guide
Block
Screws for adjusting miter bar
in miter slot.
Hide quick links:
Advertisement
Table of Contents
