Shop fox W1819 Owner's Manual page 53

Attach the auxiliary fence to the standard fence and
set it to the desired width.
Place the workpiece against the auxiliary fence and
slide the resaw barrier against the workpiece, as
shown in 67. Now clamp the resaw barrier to
the top of the table saw at both ends.
Slide the workpiece over the blade to make sure it
moves smoothly, then remove the workpiece.
Raise the blade approximately an inch, or close
to half the height of the workpiece (
whichever is less.
Plug in the table saw, turn it
stick or push block to feed the workpiece through
the blade, using a slow and steady feed rate.
Flip the workpiece end for end, keeping the same
side against the fence, and run the workpiece
through the blade.
Repeat until the blade is close to half
of the height of the board to be resawn. The ideal
completed resaw cut will leave a
when the resawing is complete as shown in
68. Leaving a 1 ⁄ " connection will reduce the risk of
8
kickback.
Turn the table saw, then separate the parts of
the workpiece and hand plane the remaining ridge to
remove it.
When finished resawing, remove the resaw barrier
and auxiliary fence, then re-install the blade guard/
spreader or riving knife and standard table insert.
68),
, and use a push
1 ⁄ " connection
8
-51-
(Front View)
. Ideal resaw workpiece setup.
68 Ideal completed resaw cut.