Shop fox W1819 Owner's Manual page 70

The spreader/riving knife mounting position can be
adjusted into alignment with the blade using the set
screws on the spreader/riving knife mounting block.
Hex Wrench 3mm ...............................................1
Hex Wrench 5mm ...............................................1
To adjust the spreader/riving knife position, do these
steps:
1. DISCONNECT THE SAW FROM POWER!
Remove the table insert.
Adjust each pair of set screws that controls the
direction required to move the mounting block so
the riving knive can be aligned with the blade (see
). Make sure to move both screws in even
increments.
Re-install the table insert.
Follow
if the spreader/riving knife is parallel with the blade
and inside the "Alignment Zone."
— If the spreader/riving knife is in the alignment
zone, no additional steps are necessary.
— If the spreader/riving knife is still not in the
alignment zone, continue adjusting the set screws
on the mounting block as necessary to correctly
position the spreader/riving knife.
Tighten the two cap screws on the mounting block to
secure the spreader/riving knife adjustment.
DISCONNECT THE SAW FROM POWER!
Bend the spreader or riving knife by hand while
installed, then follow
to determine if it is parallel with the
blade and inside the "Alignment Zone" (refer to
— If this does not work, remove it to straighten.
— If you cannot straighten it properly, replace it.
, to determine
in
).
Center
Screw
spreader/riving knife position.
-68-
Cap
Cap
Screws
Screws
Set Screw
Adjustment Block
Set screws for adjusting