Shop fox W1819 Owner's Manual page 26

Install the front rail onto the table and extension
wings with four M8-1.25 x 40 hex bolts, eight 8mm
flat washers, four 8mm lock washers, and four
M8-1.25 hex nuts, as shown in
Before final tightening, make sure the front rail is
set 3 ⁄ " below the beveled edge along the entire
16
length of the table.
: Install the 62" front rail tube onto the
50" front rail with the three M6-1 x 16 cap screws,
6mm flat washers, and 6mm lock washers, as shown
in .
Install the 82" front rail tube onto the
70" front rail with five M6-1 x 16 cap screws, 6mm
lock washers, and 6mm flat washers, as shown in
.
Attach the rear rail to the holes on the main table
using two M8-1.25 x 30 hex bolts, 8mm lock washers
and 8mm flat washers, as shown in
Secure the rear rail to the extension wings with two
M8-1.25 x 40 hex bolts, four 8mm flat washers, two
8mm lock washers and two M8-1.25 hex nuts.
.
x3
x5
.
x2
-24-
Front rail installed (W1819).
Rail Tube
Model W1819 tube attached to
front rail.
Rail Tube
Model W1820 tube attached to
front rail.
Rear rail installed (W1820).