Table of Contents
Advertisement
ICE-‐ENTRY-‐100
11 CHANGING PARAMETERS USING THE SMS
COMMANDS
All programming parameters for ICE-ENTRY-100 can also be sent by SMS
command. Each SMS command should start and stop with semicolon. If the
confirmation SMS is needed, put "+" at the beginning of the command SMS.
The first SMS is SMS with telephone numbers (TN1 – TN4). If you would like to
check which telephone numbers are programmed in ICE-ENTRY-100 please use the
following command:
;PTN;
Return SMS is (example):
;TN1=0;TN2=0;
If you would like to enter telephone numbers in to ICE-ENTRY-100 you can use the
following example:
;TN1=040713470;TN2=+38643364850;
If you would like to receive confirmation SMS write "+" before SMS command:
;+TN1=040713470;TN2=+38643364850;
Return SMS from ICE-ENTRY-100 is:
;TN1=040713470;TN2=+38643364850;
NOTE
You
parameters.
It is also possible to change different parameters with one SMS. Consider that the
SMS message should not be longer than 160 characters (included space
characters).
If you would like to change the following parameters TN1, IN1, IN2, OS1, OS2;
ID1, LN1 and CRE and would like to receive confirmation SMS, try next example:
;+TN1=+38640713470;IN1=1;IN2=1;OS1=15;OS2=1;ID1=120;LN1=1;
can
use
the
same
programming
Page
4 4
INSTALLATION
M
ANUAL
procedure
for
all
Advertisement
Table of Contents
