Dhcp; Dhcp Settings - TP-Link TL-WR940N User Manual

4.7

DHCP

Figure 4-26 The DHCP menu
There are three submenus under the DHCP menu (shown in
Client List and Address Reservation. Click any of them, and you will be able to configure the
corresponding function.
4.7.1

DHCP Settings

Choose menu "DHCP→DHCP Settings", and then you can configure the DHCP Server on the
page (shown in
Figure 4-27
Configuration Protocol) server, which provides the TCP/IP configuration for all the PC(s) that are
connected to the Router on the LAN.
DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must

have another DHCP server within your network or else you must configure the computer
manually.
Start IP Address - Specify an IP address for the DHCP Server to start with when assigning

IP addresses. 192.168.0.100 is the default start address.
End IP Address - Specify an IP address for the DHCP Server to end with when assigning IP

addresses. 192.168.0.199 is the default end address.
Address Lease Time - The Address Lease Time is the amount of time a network user will

be allowed connection to the Router with their current dynamic IP Address. Enter the
amount of time in minutes and the user will be "leased" this dynamic IP Address. After the
TL-WR940N/TL-WR941ND
).The Router is set up by default as a DHCP (Dynamic Host
Figure 4-27 DHCP Settings
41
450Mbps Wireless N Router
): DHCP Settings, DHCP
Figure 4-26