TP-Link TL-WR940N User Manual page 25

Wireless Radio - Enable or disable the wireless radio by choosing from the drop-down

list.
Wireless Network Name (also called SSID) - Enter a value of up to 32 characters. The

same name of SSID (Service Set Identification) must be assigned to all wireless devices
in your network. Considering your wireless network security, the default SSID is set to
be TP-LINK_XXXX (XXXX indicates the last unique four numbers of each Router's MAC
address). This value is case-sensitive. For example, TEST is NOT the same as test.
Region - Select your region from the drop-down list. This field specifies the region

where the wireless function of the Router can be used. It may be illegal to use the
wireless function of the Router in a region other than one of those specified in this field. If
your country or region is not listed, please contact your local government agency for
assistance.
Mode - This field determines the wireless mode which the Router works on.

Channel Width - The bandwidth of the wireless channel.

Channel - This field determines which operating frequency will be used. It is not

necessary to change the wireless channel unless you notice interference problems with
another nearby access point. If you select auto, then the AP will select the best channel
automatically.
Disable Security - The wireless security function can be enabled or disabled. If

disabled, the wireless stations will be able to connect the Router without encryption. It is
strongly recommended that you choose one of following options to enable security.
WPA-PSK/WPA2-PSK - Select WPA based on pre-shared passphrase.

TL-WR940N/TL-WR941ND
Figure 3-12 Quick Setup – Wireless
15
450Mbps Wireless N Router