TP-Link TL-WR940N User Manual page 33

MTU Size - The normal MTU (Maximum Transmission Unit) value for most Ethernet networks

is 1500 Bytes. It is not recommended that you change the default MTU Size unless required
by your ISP.
Primary/Secondary DNS - Enter one or two DNS addresses in dotted-decimal notation

provided by your ISP.
3. If your ISP provides a PPPoE connection, select PPPoE/Russia PPPoE option. And you
should enter the following parameters (Figure 4-9):
User Name/Password - Enter the User Name and Password provided by your ISP. These

fields are case-sensitive.
Confirm Password - Re-enter the Password provided by your ISP to ensure the Password

you entered is correct.
Secondary Connection - It's available only for PPPoE Connection. If your ISP provides an

extra Connection type such as Dynamic/Static IP to connect to a local area network, then you
can check the radio button of Dynamic/Static IP to activate this secondary connection.
Disabled - The Secondary Connection is disabled by default, so there is PPPoE
•
connection only. This is recommended.
Dynamic IP - You can check this radio button to use Dynamic IP as the secondary
•
connection to connect to the local area network provided by ISP.
Static IP - You can check this radio button to use Static IP as the secondary connection
•
to connect to the local area network provided by ISP.
TL-WR940N/TL-WR941ND
Figure 4-9 WAN - PPPoE
23
450Mbps Wireless N Router