Running Belt Removal - Matrix T5X-07 Service Manual

CHaPTer 9: ParT rePlaCemeNT GUide

9.6 rUNNiNG belT remoVal

1) Remove the motor cover as outlined in Section 9.1.
2) Remove the rear roller as outlined in Section 9.2.
3) Remove the deck as outlined in Section 9.3.
4) Remove the front roller as outlined in Section 9.5.
5) Remove the running belt and replace with a new belt (Figures A & B). note: New running belts should ALWAYS be installed on a new
deck surface (deck should either be flipped or replaced to gain a new surface).
fiGUre a fiGUre b
6) Tension the running belt as outlined in Section 3.5.
32