Running Belt Replacement - Matrix TF30 Service Manual

3.6 RUNN NING BELT T REPLAC
1) Remove the motor co over as outlin
2) Remove the rear rolle er as outlined
3) Remove the running deck as outl
4) Remove the front roll er as outline
5) Remove the running belt
Fig-1
5) Reverse e Steps 1-5 t to install a ru
Note1:
1. Adj just running belt tension
2. The e running dec ck is silicon o
matche d to a new ru unning belt a
:
Note:2
ADJUSTING G THE RUN NING BELT
After plac cing the tread dmill in the p
centering. T The belt may need to be a
cause the b belt to stretch h at different
direction be elow.
Step1: Loca ate the two h ex head bolt
frame at the e back of trea admill. These
Step2: Th ere should b be an equal a
the belt is to ouching one side, turn the
Manually ce enter the belt t by pushing
as they wer re loosened.
Step3: Whil e the treadm mill is running
Right bolt by y turning it cl lockwise 1/4
left tighten t the left bolt b by turning it c
remains cen ntered for se everal minute
Step4: Chec ck the tensio on of the belt
should not h hesitate or sl lip. If this occ
necessary.
All manuals and user guides at all-guides.com
CH HAPTER 3 3: Part Re
CEMENT
ned in Sectio on 3.1.
d in Section 3 3.2.
ined in Secti on 3.4.
ed in Section 3.5.( Fig-2)
unning belt.
after replace ement (Note2
on one side o onTF30/TF5
and Only T70 0-02 models
osition it will be used, the
adjusted afte er the first 2 h
rates. If the belt starts to
t on the rear of the treadm
e bolts adjus st the rear rol
amount of sp pace on eithe
e bolts count ter clockwise
the belt towa ard the cente
g at 3 mph, o observe the b
turns, and lo oosen the lef
lockwise 1/4 4 turn and loo
es.
. The belt sh hould be very
curs, tighten the belt by t
eplacemen nt Guide
Fig-2 2
2 )
50/TF50-2. N ew deck surf rfaces must A
is waxed de ck only 1 sid de
e belt must b be checked fo or proper ten
hours of use . Temperatur re and humid
o slip when a user is on it , be sure to f
mill. The bolt ts are located d at each en
ller.
er side of the running belt t and the sid
e approximat tely one full t turn on each
er. Tighten the bolts the e same amou
belt position. If it is movin ng to the righ
ft bolt 1/4 turn n. If it is mov ving to the lef
osen the righ t 1/4 turn. Re epeat step 3
y snug. When n a person w walks or run o
urning both b bolts clockwi ise 1/4 turn,
ALWAYS be
nsion and
dity, and use e
follow the
d of the
e rails. If
side.
unt of turns
t, tighten the e
ft, tighten the e
until the belt t
on the belt, it t
Repeat if
23 3