Headlight Assembly - Removal And Installation; Brake/Tail Light Bulb - Renewal - Yamaha TDM850 User Manual

7.8 Pull the bulbholder out of the base of
the headlight
clockwise to release it from the holder (see
illustration). Install the new bulb
bulbholder, then install the bulbholder in the
headlight. Make sure the rubber cover is
correctly seated. 9 Check the operation of the
auxiliary light.
8 Headlight assembly -
■ removal and installation
Removal
1 Remove the fairing (see Chapter 8).
2 On 1996-on TDM models, TRX and XTZ
models, lift the headlight out of the fairing (see
illustration).
3 On 1991 to 1995 TDM models, disconnect the
headlight wiring connectors (see illustration
7.2a), then unscrew the three nuts securing the
headlight assembly to the bracket and draw the
assembly forward and off the bracket (see
illustrations).
4 On 1991 to 1995 TDM models and XTZ
models, the headlight can be disassembled and
the lights renewed individually if required.
Installation
5 Installation is the reverse of removal. Make
sure all the wiring is correctly connected and
secured. Check the operation of the headlight
9.1 On XTZ models, remove the storage
cover to access the bulbs
8.2a Removing the headlight -
TRX models
in the
^
|§
8.3a Unscrew the nut on each side (A), and
the central nut on the bottom (B)...
and auxiliary light. Check the headlight aim (see
Chapter 1).
9 Brake/tail light bulb-
renewal
1 On TDM models, remove the seat (see
Chapter 8). On TRX models, remove the
passenger seat, though best access is obtained
by removing the side covers as well (see Chapter
8). On XTZ models
compartment cover behind the seat and remove
the cover (see illustration).
2 Turn the bulbholder anti-clockwise and
9.2 Release the bulbholder ...
8.2b Removing the headlight -
8.3b ... and remove the headlight
withdraw it from the tail light (see illustration).
3 Push the bulb into the holder and twist it anti-
clockwise to remove it (see illustration). Check
the socket terminals for corrosion and clean them
f^
if necessary. Line up the pins of the new bulb
||
with the slots in the socket, then push the bulb in
and turn it clockwise until it locks into place.
Note: The pins on the bulb are offset so it can
only be installed one way. It is a good idea to use
a paper towel or dry cloth when handling the new
bulb to prevent injury if the bulb should break and
to increase bulb life.
open the storage
4 Install the bulbholder into the tail light and turn
it clockwise to secure it.
9.3 ... and remove the bulb
Electrical system'"w
XTZ models
assembly
Staned by Stalker