KoamTac KDC20 User Manual page 114

KDC User Manual
G
ENERATION





114
Barcode Type
This field allows the user to select the type of barcodes the KDC will collect.
When the user clicks on the box, Select Symbols is enabled. A listing of the
symbologies supported by the KDC will display. To select a barcode symbology,
click on the box associated with the symbology.
Minimum Data Length
This field allows the user to define the minimum length of the scanned barcode.
The length can be between 2 and 36(KDC350L), 2 and 48(KDC350C) characters. If
the user scans a barcode that has a length of less than the defined length, the
barcode data is not collected.
The default KDC minimum barcode length defined in scan option is 4.
Therefore, users should change KDC minimum barcode length to 2 or
Note
3 to define minimum data length to 2 or 3.
Maximum Data Length
This field allows the user to define the maximum length of a scanned barcode. The
defined length can be between 2 and 256 characters. If the user scans a barcode
that has a length is greater than the defined length, the barcode data is not
collected.
Barcode Collation
This option enables the user to define a data string that the KDC will use to
compare scanned barcodes.
 Starting Position – This is the start position of the scanned barcode data to
be compared with the defined data string.
 Data String – This is the defined value to be compared with scanned
barcode data. This value can be up to 32 characters.
Collect Partial Data
This option allows the user to define partial barcode data to be collected when a
barcode is scanned. Only the partial data will be stored in the KDC.
 Start position – This is the starting position that the KDC will use when
collecting scanned barcode data.
A
PPLICATION
Revision 3.06.A3
Copyright®2014, KOAMTAC, Inc.