Loading The Cards; Pic.19 Adjusting The Card Thickness Lever; Pic.20 Preparing The Card 1; Pic.21 Preparing The Card 2 - idp SMART-30S User Manual

2.2. Loading the cards

This section shows how to load the plastic cards.

Pic.19 Adjusting the card thickness lever

Pic.20 Preparing the card 1

Pic.21 Preparing the card 2

2.2.1. Open the input hopper cover.
2.2.2. Adjust the card thickness with the
card thickness control lever.
(Caution! If the adjustment is not correct, it will
make some error. Use the type of cards in the
specification of this manual. Always keep the
card surface clean state.)
2.2.4. To separate cards from each other,
push a stack of cards back and
forth to an angle about 45 degrees
vertically.
(Static charge
significant adhesive force. These cards must be
physically separated from each other before
inserted into the feeder. If not separated,
feeding or printing problems may occur.)
20
makes cards stuck with