Post-Processing Parameters; Master Effect - Physis Piano H1 Reference Manual

3. POST-PROCESSING PARAMETERS

3.1 MASTER EFFECT

How to Access: press and hold the Key Touch labelled [EFFECT
Description: here you can activate, select and control a modulation or echo effect that you wish to apply to the output
signal. To activate an effect, press [EFFECT
show that the effect is active. Effects can be selected through the Efx parameter.
the selected Master Effect will not yield any effect if the EfxSend value under the MIXER menu is zero.
WARNING:
DELAY
The Delay (or echo) generates repetitions of the input signal. Part of the
output signal can be returned to the input as feedback, so as to generate
several different repetitions each one with a lower level than the previous.
−
Type: selects the delay type,
•
Stereo: delays are stereo, so with a stereo Sound also the
repetitions keep the stereo panorama.
•
Mono: the delays are always mono, regardless of the currently
selected sound (stereo or mono).
•
Ping pong: echoes are generated alternating left and right
channels.
−
Delay (ms): sets the time between echoes, in milliseconds.
−
Feedback: sets the quantity of signal that is sent back to the input as feedback. This affects the echoes' decay time.
−
Hi Damp: sets the cutoff frequency of a low-pass filter, that dampens the echoes with a higher frequency. By setting a
high value, the effect willresemble an old-fashioned, analog or tape delay. Echoes will sound "warmer" and "softer".
−
Level: sets the output signal level.
CHORUS
Chorus is a modulation effect which adds to the original signal a slightly
modified copy of it. The copy is cyclically detuned. The resulting sound is
"thicker" and more spatialized than the original.
−
Type: select the Chorus type,
•
Chorus 1: with one modulating signal.
•
Chorus 2: with two modulating signals in antiphase.
•
Chorus 3: with four modulating signals creating an antiphase
between the left and right channels, and at different speeds.
•
Chorus 4: with four modulating signals, each with its own phase.
−
Depth: sets the modulation depth.
−
Speed (Hz): sets the modulation speed in Hertz.
−
Delay (ms): sets a delay time (milliseconds), after which the effect starts modulating.
−
Level: sets the output signal level.
Reference Manual – Post-Processing Parameters
].
], then press it again to deactivate it. The Key Touch will change colour to
21