Table of Contents
Advertisement
9. POST-PROCESSING SECTION
As already mentioned under the panel section, Physis Piano is equipped with a signal post-processing section. Under this
section are:
-
MASTER EFFECT: adds a modulation or delay effect.
-
MASTER REVERB: applies a reverberation effect
-
MASTER EQ: applies equalization filters to the general sound.
-
MIXER: sets the volume, stereophonic options and effects send for each Sound.
NB
MASTER EFFECT and MASTER REVERB parameters are saved to both Sounds and Memories. Recalling a Sound or
Memory will also recall these parameters. When using the keyboard in Split or Layer mode, the effective MASTER
EFFECT, MASTER REVERB parameters are the ones relate to the Sound assigned to Part 1.
MASTER EQ is a general equalizer. It can be used to adapt the sound to the environment, and it is independent from
the current Sound and/or memory.
9.1 SETTING AND APPLYING AN EFFECT
The first two Key Touch left from the POST-PROCESSING section set up and activate a chorus or delay effect (MASTER
EFFECT) or a reverb (MASTER REVERB).
To activate a chorus or delay effect, press the [EFFECT
To activate a reverberating effect, press the [REVERB
In both cases, the Key Touch light will turn on.
NB
Keep in mind that the MIXER sub-section contains parameters that regulate the effect sends (EFX Send) and reverb
sends (REV Send). If these parameters are set as 0 or very low, effects will not be heard.
To set up an effect, press and hold its dedicated Key Touch. Press [EFFECT
page; press [REVERB
]. To visualize the reverb effect page.
Here you can see the delay effect video page.
To modify values, press the Key Touch [ ], [ ], [ ] or [ ] to select the field, and then [+] and [-] to modify that value.
To select an effect or reverb, place the cursor on the Efx (for effects) or Type field (for reverb), then press [+] or [-].
Parameters shown will vary according to the selected effect. The precise function for each parameter is explained on the
Reference Manual.
Press [EXIT] to return to the main Sound page.
Pressing the [F3] Key Touch activates the parameter lock for the reverb. When active, parameters will not be altered even
when different Memories or Sounds are selected. The current state of the lock appears on the top left of the screen:
•
Lock: parameters are locked
•
Unlock: parameters are unlocked
User Manual – Post-Processing section
] Key Touch.
] Key Touch
] to visualize the chorus and delay setup
EN - 33
Advertisement
Table of Contents
