Physis Piano H1 Reference Manual page 20

Reference Manual – Sound Edit Parameters
−
Speed (Hz): sets the modulation speed in Hertz.
−
Delay (ms): sets a delay time, after which the effect starts the modulation.
−
Dry/Wet: balance between the original input signal (slider on the left) and processed signal (slider on the right).
TREMOLO
Similar to the Vibrato, but instead of modulating the frequency, it modulates
the amplitude (i.e. volume) of the sound.
−
Type: select the Tremolo type,
•
Tremolo 1: with one modulating signal.
•
Tremolo 2: with two modulating signals in antiphase.
−
Depth: sets the modulation depth.
−
Speed (Hz): sets the modulation speed in Hertz.
−
Shape: modifies the waveform of the modulating signal, so as to make it softer and smoother on higher values; the
result is a softer effect.
PHASER
Generally speaking, this effect works as a Chorus or Flanger; however, it does
not add a new signal, altered in tone, to the original sound. Instead, the
Phaser adds a new signal with an altered phase. In other words, the resulting
effect is that of two machines playing the same tape but starting with a few
milliseconds of distance. This causes some frequencies to be added up or
cancelled, and is similar in sound to a Flanger, although weaker and "thinner".
−
Type: select the Phaser type. Higher Stages generate an output signal
that is richer in interferences.
−
Depth: sets the modulation depth.
−
Speed (Hz): sets the modulation speed, in Hertz.
−
Feedback: sets the quantity of signal that is sent back to the effect input as feedback; in this way the elaboration
development of the signal can be controlled.
−
Manual: tune the modulation manually.
−
Dry/Wet: balance between the original input signal (slider to the far left) and processed signal (slider to the far right).
PHA+TREM (PHASER+TREMOLO)
Phaser effect followed by Tremolo.
−
Ph. Depth: sets the Phaser's modulation depth.
−
Ph. Speed: sets the Phaser's modulation speed, in Hertz.
−
Ph. Feed: sets the quantity of signal that is sent back to the Phaser input
as feedback; in this way the elaboration development of the signal can
be controlled.
−
Ph. Manual: tune the Phaser modulation manually.
−
Tr. Depth: sets the Tremolo's modulation depth.
−
Tr. Speed: sets the Tremolo's modulation speed, in Hertz.
−
Tr. Phase: sets the phase of the Tremolo's modulation signal.
−
Tr. Shape: modifies the waveform of the Tremolo's modulating signal, so as to make it softer and smoother on higher
values; the result is a softer effect.
18