Eq Block - Physis Piano H1 Reference Manual

Reference Manual – Sound Edit Parameters
−
Sensitivity (with Type=Touch): adjust the filter's sensibility to dynamic (the pressure of fingers on the keys).
−
Foot control (with Type=Pedal): assign this function to an expression pedal, to shift the filter in real time.
−
Level: sets the output signal level.
ROTARY
This effect simulates the classical electromagnetic organ rotating diffusor,
with two selectable rotating speeds. A rotary creates a tremolo-like effect,
with an "open" sound.
−
Type: select the amount of electric rotors for the effect,
•
2 Rotors: two rotors, one for low and one for high frequencies; the
two speakers rotate at different speed, so as to create a highly
modulated sound.
•
1 Rotor: one rotor, moving the high-frequency speaker.
−
Slow Speed: sets the rotation speed of the Slow mode.
−
Fast Speed: sets the rotation speed of the Fast mode.
−
Balance: balance between low (potentiometer to the far left) and high sounds (potentiometer to the far right).
−
Speed: selects speed:
•
Slow: slow mode.
•
Fast: fast mode.
The rotation speed can also be controlled through a pedal. To do so, connect a pedal to the [FOOT CONTROLLER 1],
[FOOT CONTROLLER 2], [SOFT] or [SOSTENUTO] connectors; the same function can be performed through the Soft
and Sostenuto pedals of the three-pedal group. The function must be activated through the Pedals screen under the
FUNCTION menu. (see par 5.1).
−
Rise/Fall: sets the transition time needed to switch between Slow and Fast modes.
−
Dry/Wet: balance between the original input signal (slider to the far left) and processed signal (slider to the far right).

2.5 EQ block

How to access: press [SOUND EDIT], select the EQ block.
Description: these parameters adjust the equalizer dedicated to the currently
selected Sound. Physis Piano is not only equipped with a Master equalizer
(that can be edited by pressing and holding the [EQ
a Sound-dedicated equalizer.
The parametric equalizer is composed of three sections. Two sections control
(dampen/increase) two frequency bands (low and high), while a third section
can be assigned to a frequency range of your own choice (medium
frequencies). In this way the action range can be defined, and then the
bandwidth and level of these frequency ranges can be adjusted.
−
Low S.: gain (positive value) or dampening (negative
values) of low signals (frequencies below 180 Hz).
−
Freq.: select the frequencies controlled by the
parameter.
−
BW: Bandwidth of the middle filter, that is, the extension of
frequencies on both sides of the
Gain
the parameter
−
Gain: gain (positive value) or dampening (negative values)
of frequencies set by the
−
Hi S.: gain (positive value) or attenuation (negative values)
of high signals (frequencies above 6,3 KHz).
Freq ., that are controlled by
Freq .
parameter
] Key Touch), but also
Signal
Level
Gain
20
Freq.
BW
Frequency