Matrix U7xi Owner's Manual page 46

POWER
Your exercise bike may be powered by a power supply. The power must be plugged into the power jack, which is located in the
front of the machine near the stabilizer tube. Unplug cord when not in use.
WARNING
Never operate product if it has a damaged cord or plug, if it is not working properly, if it has been damaged, or
immersed in water. Contact Customer Tech Support for examination and repair.
HYBRID SEAT HEIGHT
To adjust the seat height on the Hybrid
Cycle, pull the orange lever under the seat
and lower the seat to the lowest position,
stand over the seat and grab the orange
lever. Pull the lever and lift until the seat
base makes contact with your pelvic bone.
UPRIGHT SEAT HEIGHT
To adjust the seat height on the Upright Cycle, locate the orange pull pin before you mount the Cycle. To raise or lower the seat,
pull the orange knob while holding the seat with the other hand and slide up or down accordingly. Make sure you are not seated
when you pull the knob or pull the seat up.
The seat height adjusts from level 1 to 15, when you see the mark "15 MAX" on the seat post, stop to pull the seat up.
46
RECUMBENT SEAT HEIGHT
To adjust the seat height on the Recumbent Cycle, locate the yellow lever
under the right side of the seat before you mount the Cycle. Place your right
hand on the orange adjustment handle under the right side of the seat. Place
feet on the ground while seated and slide forward if needed. Place feet on
pedals, gently lift lever under the right side of the seat. Using legs, slowly
push and slide the seat up or down to desired position. Release lever and
allow to lock into place.