Check Point After Repair - Videocon SPRING-WM VSP70LPW-SFK Service Manual

6. SERVICE INFORMATION

6-4. CHECK POINT AFTER REPAIR

After repairing, be sure to make the following trial operation to see if the washer operates normally.
CheckPoint
1) Insulation resistance
2) Safety device
3) Safety designated parts
4) Wiring
5) Screwsand Nuts
6) Removal ofuseless
matter
7)Lekage ofoiland water
8) Power-cord
9) Level Installation
Unplug the cord from the power outlet and turn on all the timers.Then
measure the insulation resistance between the plug (both of 2pins) and
grounding wire of themachine.
The measured value should be more than1M Ohm
In the following case, check sufficiently.
1)Replace the electrical parts with new ones.
2)Used in a moistplace.
3)Used more than 5years.
Check the full stoptime of the spin basket.
Braking time should be as follows.
Load
Noload
Ratedload
Replace withthe designated parts inthecase the used parts are not proper.
(Refer to'*"marked parts inthe parts list)
Check tosee ifthe lead wireisproperly connected without looseness or
overtension and taping and setting are firmlyperformed.
Check toseeifthe screws,nuts, etc are firmly tightened and the screw
locks are applied.
Check toseeifuseless matters (Screws,bits ofwire, etc) are left inside
the machine.
Check toseeifoilorwater
motors and connection ofd.v-case.
Check toseeifthe cord, the plug, the outlet etc, are not damaged. Do not
use table tape with multi-wiring.
Check tosee ifthe machine installed horizontally.
Inspection & Judgement
Normalstoptime
Witin7sec.
Within10sec.
leaks out around bellow-spinning, gear box,
22