Troubleshooting - Videocon SPRING-WM VSP70LPW-SFK Service Manual

6. SERVICE INFORMATION
6-3. TROUBLE SHOOTING
TYPICAL FAILURE
Wash No agitation or
Rinse poor agitation
Excessive
noise during
agitation
Drain No Drain
Drainning does
not stop
Spin No spinning
POSSIBLE CAUSE
Power plug is not connected properly
Defective Motor
Defective Timer
Defective Gear-Box
Clothes or objects bit in pulsator gap
Defective mounting of pulsator screw
Belt loose
Too large amout of wash load
Coin or button between pulsator andtub
Defective Bearing Case
Defective fixing of pulley or transformed
Drain Hose is not lowered
Lints accumulated in Drain Hose
Cock Rod A is broken or seperated
Defective DV Bellow
D.V-Spring is broken away or elesticity is
insufficient
Guide-A.T is derailed or defective Guide-A.T
Lid is open
Out of adjustment of Safety Switch or
defective Safety Switch.
Defective Spin imer
Brake wire is broken.
20
REPAIR
Insert power plug correctly
Replace
Remove pulsator and check.
Remove objects
Fixing pulsator
Adjust the belt tention
Take out some clothes
Remove objects
Replace Bearing Case
Adjust pulley or replace it
Make sure to lower drain
hose
Clean or replace Hose
Replace or connet
Adjust or replace
Adjust or replace D.V-spring
Adjust or replace
Close the lid adn advise
customer
Adjust fixing positon of
Safety Switch or replace
Safety Switch
Replace
Replace B r a k e w i r e