ZyXEL Communications Prestige 314 PLUS User Manual page 75

The Type, Local and Global Start/End IPs are configured in menu 15.1.1.1
Ordering Your Rules
Ordering your rules is important because the Prestige applies the rules in the order that you specify. When a
rule matches the current packet, the Prestige takes the corresponding action and the remaining rules are
ignored. If there are any empty rules before your new configured rule, your configured rule will be pushed up
by that number of empty rules. For example, if you have already configured rules 1 to 6 in your current set
and now you configure rule number 9. In the set summary screen, the new rule will be rule 7, not 9.
Now if you delete rule 4, rules 5 to 7 will be pushed up by 1 rule, so as old rule 5 becomes rule 4, old rule 6
becomes rule 5 and old rule 7 becomes rule 6.
FIELD
Set Name
Action
Select Rule
You must press [ENTER] at the bottom of the screen to save the whole set. You
must do this again if you make any changes to the set – including deleting a rule.
No changes to the set take place until this action is taken.
Selecting Edit in the Action field and then selecting a rule brings up the following menu, Menu 15.1.1.1 -
Address Mapping Rule in which you can edit an individual rule and configure the Type, Local and Global
Start/End IPs.
NAT
Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
(described later) and the values are displayed here.
Table 4-5 Fields in Menu 15.1.1
Enter a name for this set of rules. This is a required field. If this
field is left blank, the entire set will be deleted.
The default is Edit. Edit means you want to edit a selected
rule (see following field). Insert Before means to insert a rule
before the rule selected. The rules after the selected rule will
then be moved down by one rule. Delete means to delete the
selected rule and then all the rules after the selected one will
be advanced one rule. None disables the Select Rule item.
When you choose Edit, Insert Before or Delete in the
previous field the cursor jumps to this field to allow you to
select the rule to apply the action in question.
DESCRIPTION EXAMPLE
NAT_SET
Edit
1
4-11