ZyXEL Communications Prestige 314 PLUS User Manual page 98

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
FIELD
Rem IP Address If you have a Static IP Assignment, enter the IP address assigned to
the remote node.
Rem IP Subnet If you have a Static IP Assignment, enter the subnet mask assigned
Mask to the remote node.
My WAN Addr Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and
each end must have a unique address within the WAN network
number. If this is the case, enter the IP address assigned to the WAN
port of your Prestige. Note that this is the address assigned to your
local Prestige, not the remote router.
Network Use the [SPACE BAR] to select either Full Feature, None or SUA
Address Only. See the NAT chapter for a full discussion on this feature.
Translation
Metric The metric represents the "cost" of transmission for routing purposes.
IP routing uses hop count as the measurement of cost, with a
minimum of 1 for directly connected networks. Enter a number that
approximates the cost for this link. The number need not be precise,
but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Private This parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept
private and not included in RIP broadcast. If No, the route to this
remote node will be propagated to other hosts through RIP
broadcasts.
RIP Press the [SPACE BAR] to select the RIP direction. Options are
Both, None, In Only, Out Only or None.
Version Press the [SPACE BAR] to select the RIP version. Options are RIP-1,
RIP-2B or RIP-2M.
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The Prestige
supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).
Press the [SPACE BAR] to enable IP Multicasting or select None to
disable it. See the previous Part for more information on this feature.
Once you have completed filling in the Network Layer Options Menu, press [ENTER] to return to menu 11.
Press [ENTER] at the message "Press ENTER to Confirm..." to save your configuration, or press [ESC] at
any time to cancel.
5-10
DESCRIPTION EXAMPLE
192.168.1.1
255.255.255.0
SUA Only
1 to 15
Yes
None
(default)
RIP-1
None
Remote Node Setup