Turning On Your Prestige; Figure 2-3 Initial Screen; Figure 2-4 Password Screen - ZyXEL Communications Prestige 314 PLUS User Manual

2.5

Turning on Your Prestige

At this point, you should have connected the console port, the LAN port(s), the WAN port and the power
port to the appropriate devices or lines. Plug the power adapter into a wall outlet. The PWR LED should be
on. The SYS LED will come on after the system tests are complete. The WAN LED and one of the LAN
LEDs come on immediately after the SYS LED comes on, if proper connections have been made to the LAN
and WAN ports.
2.5.1 Initial Screen
When you turn on your Prestige, it performs several internal tests as well as line initialization.
After the tests, the Prestige asks you to press [ENTER] to continue, as shown next.
Copyright (c) 1994 - 2001 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:a0:c5:01:23:45
initialize ch =1, ethernet address: 00:a0:c5:01:23:46
Press ENTER to continue...
2.5.2 Entering the Password
The login screen appears after you press [ENTER], prompting you to enter the password, as shown next.
For your first login, enter the default password 1234. As you type the password, the screen displays an (X)
for each character you type.
Note that if there is no activity for longer than five minutes after you log in, your Prestige will automatically
log you out and will display a blank screen. If you see a blank screen, press [ENTER] to bring up the login
screen again.
Hardware Installation & Initial Setup
Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch

Figure 2-3 Initial Screen

Enter Password : XXXX

Figure 2-4 Password Screen

2-5