Table of Contents
Advertisement
PARKING BRAKE ADJUSTMENT/
BRAKE FLUID LEVEL INSPECTION
4. Measure:
5. Adjust:
Adjustment steps:
• Loosen the locknut 1.
• Turn the adjusting bolt 2 in or out until the
• Tighten the locknut.
BRAKE FLUID LEVEL INSPECTION
1. Place the snowmobile on a level surface.
2. Check:
NOTE:
For a correct reading of the brake fluid level, make
sure that the top of the handlebar brake master cyl-
inder reservoir is horizontal.
Brake fluid may corrode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
2-32
• Brake pad clearance (a + b)
Out of specification → Adjust.
Brake pad clearance (a + b):
1.5 ~ 2.0 mm (0.059 ~ 0.079 in)
• Brake pad clearance
specified clearance between the parking brake
pad 3 and brake disc 4 is obtained.
Parking brake adjusting locknut:
15 Nm (1.5 m · kg, 1.1 ft · lb)
• Fluid level
Fluid level is under the lower level line a →
Fill to the proper level.
Recommended brake fluid:
DOT 4
CAUTION:
INSP
ADJ
Advertisement
Table of Contents
Troubleshooting
