Yamaha FX10X 2008 Service Manual page 252

CONNECTING RODS AND PISTONS
NOTE:
• Align the projections on the big end bearings with
• Be sure to reinstall each big end bearing in its
• While compressing the piston rings with piston
• Make sure that the "Y" marks a on the connect-
• Make sure that the characters b on both the con-
5-66
4. Lubricate:
• Piston
• Piston rings
• Cylinder
(with the recommended lubricant)
Recommended lubricant:
Engine oil
5. Lubricate:
• Bolt threads
• Nut seats
(with the recommended lubricant)
Recommended lubricant:
Molybdenum disulfide grease
6. Lubricate:
• Crankshaft pins
• Big end bearings
• Connecting rod inner surface
(with the recommended lubricant)
Recommended lubricant:
Engine oil
7. Install:
• Big end bearings
• Connecting rod assembly 1
(into the cylinder and onto the crankshaft pin).
• Connecting rod cap
(onto the connecting rod)
the notches in the connecting rods and connect-
ing rod caps.
original place.
ring compressor 2, install the connecting rod
assembly into the cylinder with the other hand.
ing rods face towards the right side (AC magneto
rotor side) of the crankshaft.
necting rod and connecting rod cap are aligned.
Piston ring compressor:
90890-05158, YM-08037
ENG