Table of Contents
Advertisement
CABLE ROUTING
1 ECU (engine control unit)
2 Load control relay
3 Headlight relay
4 Fuel injection system relay
5 Radiator fan motor relay
6 Fasten the wire harness and sta-
tor coil lead to the front frame
with the plastic band.
7 To the left handlebar switch
8 To the AC magneto
9 To the radiator
0 Main fuse
A Starter relay
B Coolant temperature sensor cou-
pler
C Coolant temperature sensor sub-
lead
D Fasten the wire harness at the
positioning tape to the rear frame
cross member with the plastic
band.
E Oil tank breather hose
F To the main switch
G Oil level switch coupler
H Main switch coupler
I Thermostat outlet hose
J Fasten the wire harness to the
frame rear cross member with
the plastic band.
K Fasten the wire harness and fuel
tank breather hose to the frame
rear cross member.
L Fasten the hose protector of the
fuel tank breather hose to the
rear frame cross member with
the plastic band, making sure to
fasten it after the bend in the
hose as shown in the illustration.
M Fuel tank breather hose
N The ends of the hose protector
should be 20 mm (0.79 in) or less
from each other.
O Fasten the fuel tank breather
hose with the holder, making
sure to position the portion of the
hose from the fuel tank to the
rear of the portion after the bend
in the hose.
P Face the cutout in the hose joint
flange downward.
Q Bend the fuel tank breather hose
as shown in the illustration, and
then fasten it after the bend in
the hose with the holder as
shown in the illustration. Face
the open ends of the holder
toward the fuel tank.
CABLE ROUTING
9-28
SPEC
Advertisement
Table of Contents
Troubleshooting
