Yamaha FX10X 2008 Service Manual page 393

1 To the auxiliary DC jack
(FX10MT/FX10MTR/
FX10MTRA)
2 Throttle cable
3 Radiator fan motor coupler
4 Wire harness
5 Fuel injection system sub-wire
harness coupler
6 Speed sensor coupler
7 To the radiator fan motor
8 Fasten the speed sensor lead to
the frame rear cross member
with the plastic band.
9 Pass the auxiliary DC jack lead
between the radiator fan motor
lead and the fuel injection system
sub-wire harness. (FX10MT/
FX10MTR/FX10MTRA)
0 Fuel tank breather hose
A Fasten the speed sensor lead
and fuel tank breather hose to
the frame rear cross member
with the plastic band, making
sure not to pinch the hose.
B Speed sensor lead
C Fasten the speed sensor lead
and fuel tank breather hose to
the frame with a plastic locking
tie, and then cut off the excess
end of the tie.
D Face the ends of the hose clamp
rearward.
E Install the fuel tank breather hose
completely onto the hose joint,
making sure that the end of the
hose contacts the frame.
F Fasten the corrugated tube of the
speed sensor lead with the hold-
ers.
G Speed sensor
H Water pump inlet hose
I Fasten the wire harness, at the
portion just before the leads split,
to the frame rear cross member
with the plastic band.
J Water pump outlet hose (to oil
cooler)
K Throttle body outlet hose
L Water pump outlet hose (to water
jacket)
M Fasten the wire harness, oil pres-
sure switch sub-lead, and crank-
shaft position sensor lead to the
frame rear cross member with
the plastic band.
N Fasten the wire harness and sta-
tor coil lead to the front frame
with the plastic band.
O Stator coil lead
CABLE ROUTING
9-32
SPEC