Assembly - Yamaha FX10X 2008 Service Manual

SECONDARY SHEAVE
5. Measure:
• Ramp shoe thickness a
Out of specification → Replace the ramp
shoe.
Wear limit:
1.0 mm (0.04 in)

ASSEMBLY

1. Install:
• Secondary sheave spring 1
• Spring seat 2
NOTE:
Hook the end of the secondary sheave spring into
the spring holes in the fixed sheave. Hook the other
end of the spring into the holes in the spring seat.
Standard spring position:
2-6 (FX10/FX10RT/FX10RTR/FX10RTRA)
1-6 (FX10MT/FX10MTR/FX10MTRA)
Installation steps:
• Hold the spring seat 1 and turn the fixed
sheave 2 counterclockwise to the specified
angle a.
NOTE:
The holes in the spring seat should align with the
bolts on the sliding sheave.
a = (sheave hole number + spring seat hole
number) × 10
Twist angle:
80° (FX10/FX10RT/FX10RTR/
FX10RTRA)
70° (FX10MT/FX10MTR/FX10MTRA)
• Push down on the spring seat until the bolts
come through the holes.
• While pushing down on the spring seat, install
the nuts and tighten them to the specified
torque.
Spring seat nut:
23 Nm (2.3 m · kg, 17 ft · lb)
4-14
POWR
TR