Installation - Yamaha FX10X 2008 Service Manual

6 2 4
7 3 1
CYLINDER HEAD

INSTALLATION

1. Install:
• Cylinder head
NOTE:
Pass the timing chain through the timing chain cav-
ity.
2. Tighten:
• Cylinder head bolts (M10)
8 NOTE:
The tightening procedure of the cylinder head bolts
is angle controlled, therefore tighten the bolts using
the following procedure.
5
Tightening steps:
• Lubricate the cylinder head bolts and washers
with engine oil.
• Install the washers and cylinder head bolts.
• Tighten the cylinder head bolts in the proper
tightening sequence as shown.
• Loosen and retighten the cylinder head bolts in
the proper tightening sequence as shown.
5-28
ENG
Cylinder head bolt (M10):
1st:
25 Nm (2.5 m · kg, 18 ft · lb)
Cylinder head bolt (M10):
2nd:
25 Nm (2.5 m · kg, 18 ft · lb)