Haier UDW603 Instruction And Installation Manual page 10

attached to the water supply tap as shown in fig 2. No other type of connection is
acceptable. The water supply hose must not, under any circumstances, be cut as it
contains electrical parts which are live. If the hose length is not adequate to make a proper
connection, the hose must be replaced with one which is long enough. This hose is
available from specialised retailers and service centres.
Drain hose connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the
sink, making sure to avoid bending or crimping it. The free end of the hose must be at a
height between 40 and 100cm and must not be immersed in water (see Fig 3).
Electrical Connection
Check that the voltage and frequency values for the current in the home correspond to
those on the rating plate (located on the inner door of the appliance) and that the electrical
system is correct for the maximum voltage on the rating plate. Insert the plug into an
electrical socket which is properly earthed. The earthing of the appliance is a safety
requirement mandated by law. If the electrical socket to which the appliance must be
connected is not appropriate for the plug, replace the whole cable rather than using
adaptors or similar as they could cause overheating and burns.