Depaepe Telecom HD2000 User Manual page 37

Download Device Used to download the change you have made.
Configuration
Reset To factory Restore the phone to factory's configuration.
settings
Distinctive Ring Caller ID must be configured. Select a Distinctive Ring Tone 1
Tone through 3 for a particular Caller ID. The HD2000IP will ONLY use
selected ring tones for particular Caller IDs. For all other calls, the
HD2000IP will use System Ring Tone. When selected and no Caller
ID is configured, the selected ring tone will be used for all incoming
calls.
System Ring Tone System ring tone. Default is North American standard.
Adjust system ring tone frequencies and cadences based on local
telecom standard.
Call Progress Tones Using these settings, users can configure ring or tone frequencies
based on parameters from local telecom. By default, they are set to
North American standard.
Frequencies should be configured with known values to avoid
uncomfortable high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the
period of silence. In order to set a continuous ring, OFF should be
zero. Otherwise it will ring ON ms and a pause of OFF ms and then
repeat the pattern. Up to three cadences are supported.
Restore User can restore the before configuration from the configuration file
Configuration saved at local pc
37