Depaepe Telecom HD2000 User Manual page 27

Outgoing call without
Registration
Local SIP port
Local RTP port
Use Random Port
Refer-To Use Target
Contact
Voice Mail user ID
Intercom Dial codes
Pickup Dialcodes
minutes) the HD2000IP refreshes its registration with the
specified
registrar. The default interval is 60 minutes (or 1 hour). The
maximum
interval is 65535 minutes (about 45 days).
Default is No. If set to "Yes," user can place outgoing calls even
when not registered (if allowed by ITSP) but is unable to receive
incoming calls.
This parameter defines the local SIP port the HD2000IP will
listen and transmit. The default value for FXS port is 5060. The
default value for FXO port is 5062
This parameter defines the local RTP-RTCP port pair the
HD2000IP will listen and transmit. It is the base RTP port for
channel 0. When configured, channel 0 will use this port _value
for RTP and the port_value+1 for its RTCP; channel 1 will use
port_value+2 for RTP and port_value+3 for its RTCP. The
default value for FXS port is 5004. The default value for FXO
port is 5008.
This parameter, when set to Yes, will force random generation of
both the local SIP and RTP ports. This is usually necessary
when multiple HD2000IP are behind the same NAT.
Default is NO. If set to YES, then for Attended Transfer, the
"Refer-To" header uses the transferred target's Contact header
information.
The number for check voice mail
Dial this code for intercom feature
Dial this code for pickup feature
27