Standard Controls - Bosch MIC440 Installation And Operation Manual

MIC440 Explosion Protected CCTV Camera System| Installation and Operation Manual
MIC-USB485CVTR and Universal Camset Software Installation
Universal Camset comes with WHQL certified drivers for the MIC-USB485CVTR
that must be installed prior to connecting the converter to the PC.
To install the drivers please do the following:-
1. Locate the USB DRIVERS.EXE
click to begin and follow the on screen instructions to install; these are the
required drivers for using the MIC-USB485CTR.
2. Locate the CAMSET INSTALLER.MSI
follow the on screen instructions to install.
3. Once installed a Universal Camset Icon will appear on your PC Desktop.
4. When opened the Universal Camset will display the Standard Controls
Tab as shown overleaf.
Providing the USB drivers have been installed successfully, you can then plug the
MIC-USB485CVTR into a PC via the USB port. If your converter is being plugged
in for the first time your system should recognise the device and inform you that
the hardware has been installed successfully.
The MIC-USB485CVTR should appear in the Comm Port selection list as USB and
as a virtual Comm Port, e.g "comm2" (for legacy support). Universal Camset has
been optimised to work with this converter in USB mode; therefore users should
select "USB" for maximum functionality and reliability.
The MIC-USB485CVTR has a status LED indicating its current state, by sending a
manual command e.g. Left or Right, you should see the LED flash. Transmitted
data from the converter is indicated by a
data a green LED will flash.
Bosch Security Systems
in the Universal Camset Folder, double
and then double click to begin,
red flashing LED flash and upon receiving
Commissioning the MIC440 using Universal Camset
Universal Camset is a Windows PC based configuration software from BOSCH
Security Systems; it is issued free on the CD that comes with each MIC camera.
Universal Camset supersedes all previous versions of Camsets used.

Standard Controls

Universal Camset opens on the
highlighted area contains the Boot messaging, MIC settings and Camset Settings
controls.
Issue 6
EN | 23
Standard Controls tab as shown above; the